Parking Brake, Checking

TEST SEQUENCE: 

-- Drive The Vehicle With The Rear Wheel On The Test Rollers

Do Not Switch Off The Ignition

-- As Soon As The Rollers Reach A Speed Between 3 km/h And 9 km/h, "T U V Mode" Is Activated.

"Parking Brake In Diagnostic Mode" Appears In The Instrument Cluster When T U V Mode Is Activated.

The "Parking Brake" Display In The Instrument Cluster Will Start To Blink

The EPB Functions As Follows: 

The Brakes Do Not Close Once, But Rather Close A Bit Each Time The Button Is Pressed.

The Tension Is Sufficient For Measuring After A Few Steps.

Pay Attention The Display In The Brake Test Stand.

One Press On The Button Releases The Brakes Again.

Prerequisite For "T U V Mode" : 

-- Ignition On

-- Front Wheels, Speed = 0 km/ h

-- Rear Wheels, Speed min. = 3, max. 9 km/h.

"Parking Brake In Diagnostic Mode" Appears In The Instrument Cluster When T U V Mode Is Activated.

The "Parking Brake" Display In The Instrument Cluster Will Start To Blink