General Information
The Testing Takes Place On A Test Stand.
When Testing, Manual Transmission Vehicles Must Be In Idle And Automatic Transmission Vehicles Must Be In Driving Position N.
Always Observe The Test Stand Manufacturer Instructions.
NOTE:
Electronic Brake Control Systems Are Inoperative When The Ignition Is Switched Off.
If Testing Equipment Is Needed On Road Tests, Follow The Information Below:
WARNING:
Distraction And Testing Equipment That Is Not Secured Properly Increase The Risk Of An Accident.
The Passenger Airbag Could Be Dangerous If It Deploys During An Accident.
- Operating Testing Equipment While Driving Is A Distraction.
- Testing Equipment That Is Not Secured Probably Increases The Risk Of Injury.
- Position The Passenger's Seat As Far Back As Possible.
- Only Use The Vehicle Diagnostic Tester.
- Testing Equipment -1- Must Lie Flat On The Passenger's Lap As Shown In The Illustration And Must Only Be Operated By That Passenger.