-- Brake Rotor, Removing
To Avoid A False Measurement, Place The Brake Rotor On A Surface That Will Not Conduct Electricity (For Example, A Wooden Table).
The Surface Must Be Clean And Dry
The Brake Rotor Must Be Clean And Dry
-- Place The :VAS6813 Again Flush On The Outer Edge Of The Brake Rotor.
The Measurement Must Take Place Again On All Three Measurement Locations To Guarantee A Correct Check.
-- Move The :VAS6813 -1- Back Along The Outer Edge -2- Until The Laser Beam Points Exactly On The Mark -D- On The Brake Rotor.
-- Determine The Wear On All Three Measurement Locations Of The Brake Rotor From "1 To 3".
-- Read The Displayed Value On The :VAS6813
If One Of The Three Wear Values -C- Is Reached Or Falls Short The Brake Rotor Must Be Replaced.
If There Is Abrasion Both Brake Rotors On Both Sides Of The Axle Must Always Be Replaced.