Variable convertible top compartment, removing and installing
1 - Variable convertible top compartment
- Removing
- Move convertible top into such a position that convertible top compartment is open.
- Lift up side lining in convertible top compartment.
- Remove bolts left and right - 2 - (2x).
- Close convertible top.
- Open luggage compartment lid.
- Remove lid of convertible top compartment → Convertible top compartment lid, assembly overview .
- Remove handle mount trim → Handle mount trim, assembly overview .
- Detach Bowden cables from clips.
- Using a large, flat screwdriver - 6 - , work along between convertible top compartment side section - 4 - and console - 3 - and carefully detach convertible top compartment from console - 5 - (secured with adhesive tape)
- Disconnect connector to microswitch - 7 - on right side.
- Detach Bowden cables from clips.
- Close luggage compartment lid.
- Move convertible top back into position "Convertible top compartment open".
- Second mechanic is required to lift out.
- Position handle mount trim on variable convertible top compartment.
- Remove luggage compartment side trim on left → Left side trim, assembly overview and right → Right side trim, assembly overview .
NOTE:
- The variable convertible top compartment must be lifted at sides of frame section, do not hold convertible top compartment in center and extend mechanism.
- Lift out variable convertible top compartment - 1 - at both sides on side sections - 4 -.
- Make sure Bowden cables do not catch.
2 - Bolts (2x)
- Tightening torque 2 Nm
3 - Convertible top compartment side lining
4 - Convertible top compartment side section
5 - Flat screwdriver
6 - Console
7 - Microswitch connector