Fuel tank, draining
Special tools, testers and auxiliary items required
Fuel siphoning unit VAS 5190
Work procedure
Observe safety precautions → Safety precautions when working on fuel supply system .
Observe rules for cleanliness → Rules for cleanliness .
CAUTION:
- Observe procedures for disconnecting battery →
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT, CABRIOLET
- Push cover over battery toward the right - arrow 1 - and remove it upward - arrow 2 -.
- With ignition switched off, disconnect Battery Ground (GND) strap - arrow -.
CAUTION:
Secure Ground (GND) wire of fuel extraction unit VAS 5190 to a bare area of the chassis.
- Pull cone piece - 2 - from shaft piece - 1 - of fuel siphoning device VAS 5190.
- Using insulating tape, apply a mark - arrow - on hose at length - a - = 1,465 mm from end of suction hose.
- Remove fuel filler cap from fuel filler tube.
- Screw shaft piece - 1 - of fuel extraction unit VAS 5190 on to fuel filler tube of fuel tank.
- Push suction hose as far into fuel tank until the mark applied earlier - arrow - is positioned on shaft piece.
NOTE:
- If using a siphoning device without a shaft piece, proceed basically in the same manner.
- In this case, apply a mark - arrow - using insulating tape on hose at length - a - = 1,400 mm from end of suction hose. The suction hose is inserted correctly when the marking applied earlier stands opposite the lip of fuel filler tube.
- If the hose can only be inserted with difficulty, coat it thinly with engine oil. Never use lubricants containing silicon.
- Drain fuel tank through fuel filler tube.
- Carefully pull out suction hose.
- Connect battery. Observe safety precautions after connecting battery →
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT, CABRIOLET