Fuel tank, draining
Special tools, testers and auxiliary items required
- Wrench T10202
- Fuel siphoning unit VAS 5190
Work procedure
Observe safety precautions → Safety precautions when working on fuel supply system .
Observe rules for cleanliness → Rules for cleanliness .
CAUTION:
- Observe procedures for disconnecting battery →
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT, CABRIOLET
- Push cover over battery toward right - arrow 1 - and remove it upward - arrow 2 -.
- With ignition switched off, disconnect Battery Ground (GND) strap - arrow -.
CAUTION:
Secure Ground (GND) wire of fuel extraction unit VAS 5190 to a bare area of the chassis.
- Pull cone piece - 2 - from shaft end - 1 - of fuel extraction unit VAS 5190.
- Using insulating tape, apply a mark - arrow - on hose at length - a - = 1,865 mm from end of suction hose.
- Remove fuel filler cap from fuel filler tube.
- Screw shaft end - 1 - of fuel extraction unit VAS 5190 on to fuel filler tube of fuel tank.
- Push suction hose as far into fuel tank until mark applied earlier - arrow - is positioned on shaft end.
NOTE:
- If using a siphoning device without shaft end, proceed basically in the same manner.
- In this case, apply a mark - arrow - using insulating tape on hose at length - a - = 1,800 mm from end of suction hose. The suction hose is inserted correctly when the marking applied earlier stands opposite the lip of fuel filler tube.
- If the hose can only be inserted with difficulty, coat it thinly with engine oil. Never use lubricants containing silicon.
- Drain fuel tank through fuel filler tube as much as possible.
- Carefully pull out suction hose.
- Remove rear seat bench →
- 72 - SEAT - FRAMES
- 72 - SEAT - FRAMES for BODY INTERIOR - CABRIOLET
- Unbolt cover for right locking flange - arrows -.
- Disconnect electrical harness connector - 1 - at right locking flange.
- Disengage electrical harness connector - 2 - and lay it aside.
CAUTION:
The fuel system is under pressure! Before opening system, place rags around the connection area. Then release pressure by carefully loosening the connection.
- Disconnect fuel line - 1 - from locking flange by pressing release button.
- Disconnect ventilation line - 2 - by pressing release buttons.
- Remove locking ring with wrench T10202.
- Pull locking flange and sealing ring from opening of fuel tank.
- Disconnect electrical connection on the inner side of the locking flange - arrow -.
- Insert suction hose, a dimension of - x - = 800 mm in length, through right opening of fuel tank into left fuel tank chamber.
- Drain left fuel tank chamber.
- Install right locking flange again
Installing , observing notes for connecting battery →
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT, CABRIOLET