Parking Lamp M1 / M3 - bulb, replacing

Removing

CAUTION:

Fig 1: Evaporative Emission Canister Purge Regulator Valve N80 And Air Duct

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove screws - arrows -.
Remove Evaporative Emission (EVAP) Canister Purge Regulator Valve 1 N80 - 1 - at air duct.
Remove air duct - 2 -.

Fig 2: Releasing Retaining Clip And Detaching Housing Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release retaining clip - arrow - and detach housing cover for high beam/parking lamp from headlamp housing.

Fig 3: Identifying Bulb, Spring Clips, And Electrical Connection

Courtesy of VOLKSWAGEN UNITED STATES, INC.

NOTE:

Fig 4: Pulling Bulb Holder From Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing

Install in reverse order of removal, noting the following:

CAUTION:

Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
When installing housing cover, ensure proper seating. Water intrusion will damage headlamp.

Insert new bulb in bulb holder.
Press parking lamp bulb holder into reflector until felt to engage.
Position high beam headlamp bulb at lower spring clip.
Push high beam headlamp bulb into housing (overcome resistance of upper spring clips).