Rear light/bulb carrier in rear fender - Sedan, removing and installing
Removing
- Turn light switch to position "0".
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Fold pre-punched area - 2 - of luggage compartment lining forwards.
- Remove fastener - 1 - (17 mm hex socket ).
- Swivel rear light outwards - arrow - , and at the same time disengage retaining pins from body.
- Disconnect electrical connection at bulb carrier.
- Press together retaining tabs - arrows - and remove bulb carrier - 1 - from rear light.
- Turn bulbs to remove them from their holders.
Installing
Install in reverse order of removal, noting the following:
NOTE:
- Ensure seal between body and rear light housing seals completely.
- Fit rear light in position on body and press retaining pins into holes.
Tightening torque
| Component - fastener | Nm |
| Rear light to body - screw | 3.5 |