Adapter cable for HID headlamp bulb control module, removing and installing
CAUTION:
- HIGH VOLTAGE!
- Always disconnect negative ( - ) battery terminal prior to working on parts of HID headlamp components marked with yellow "HIGH VOLTAGE" warning symbols.
Removing
- Remove headlamp → Headlamps, removing and installing .
- Remove screws - 1 - and - 2 -.
- Release retaining clip - 3 - in direction of - arrow - and detach housing cover from headlamp housing.
- Remove screws - arrows -.
- Remove control module - 1 - from housing cover for headlamp housing.
- Disconnect electrical connection - 1 -.
NOTE:
- Disregard - 2 -.
- Disconnect electrical connection - 4 - at HID headlamp bulb.
- Remove wiring - 1 - and adapter cable - 3 - from retainer - 2 -.
- Guide adapter cable out of housing cover - 5 -.
Installing
Install in reverse order of removal, noting the following:
- Insert adapter cable and electrical wiring in retainer.
- Check gasket between control module for gas discharge lamp and headlamp housing.
- Install headlamp Installing .
- Reconnect battery. Required steps Reconnecting .
Tightening torque
| Component - fastener | Nm |
| Control module to headlamp - screw | 1 |