Bowden cable for backrest lock, removing and installing

1 - Holder

2 - Holder

3 - Bowden cable adjusters (2x)

4 - Bowden cables for backrest lock (2x)

• Removing 

• Remove seat → Seat, assembly overview .
• Attach fixture for seat repair VAS 6136 to engine and transmission holder VAS 6095.
• Attach front seat to fixture for seat repair VAS 6136.
• Remove backrest → Front seat backrest, assembly overview .

• Remove backrest cover panel → Backrest cover panel, removing and installing .
• Pry out staples - 10  - (4x) on left and right.
• Remove velcro strips - 9  - (4x) on left and right.
• Detach piping on side - 5  - (2x).

• Pry out piping at bottom - 8  - (3x).
• Use pliers to disengage tabs -7- (2x) at bottom left and right.
• Use screwdriver to pry Bowden cables out of mounts -6- (2x) on left and right.
• Remove Bowden cables -4- (2x) upward.

• Push cover - 11  - upward in direction of - arrow  -.
• Detach Bowden cables at holders -1- and -2-.

• Installing 

• Install Bowden cables for backrest lock in reverse order of removal.
• Set Bowden cables -4- (2x) with adjusters -3- (2x). Make sure pins at bottom left and right are released simultaneously on actuating easy-entry facility handle - 12  -.

5 - Side piping (2x)

6 - Mounts (2x)

7 - Tabs (2x)

8 - Bottom piping (3x)

9 - Velcro strips (4x) on left and right

10 - Staples (4x) on left and right

• Commercially available.
• Only use upholstery stapler.

11 - Cover

12 - Handle of easy-entry facility