Front passenger airbag, assembly overview: Notes
CAUTION:
Observe safety precautions for working on airbag →
Safety precautions when working on airbag .
1 - Passengers airbag unit
- Removing
- Disconnect battery Ground (GND) strap.
- Remove glove compartment → Glove compartment, assembly overview .
- Disconnect connector behind airbag unit Disconnecting airbag connector .
CAUTION:
Never unplug connector - 5
- (2-pin) at front passengers airbag unit.
- Remove brace - 7 -.
- Remove supports - 2 - behind airbag unit.
- Remove nut - 3 - (4x).
- Remove airbag unit.
- Put airbag unit down with impact cushion facing upward.
- Installing
- Install airbag unit.
- Ensure connector behind airbag unit engages properly (audibly) Disconnecting airbag connector .
- Switch ignition on.
CAUTION:
There must be no one in the vehicle when the battery is being connected.
- Connect battery Ground (GND) strap.
2 - Support
- Must be replaced after airbag triggering.
- Remove front passengers airbag unit.
- Remove bolts - 4 - (4x).
3 - Nut (4x)
- Must be replaced after airbag triggering
- Tightening torque 9 Nm
4 - Bolts (4x)
- Must be replaced after airbag triggering
- Tightening torque 9 Nm
5 - Connector
6 - Frame for airbag unit
- Must be replaced after airbag triggering
- Remove front passengers airbag unit.
7 - Brace