Left fuel delivery unit with Transfer Fuel Pump (FP) G6 , removing and installing: Installing
- Tightening torque → Left fuel delivery unit with Transfer Fuel Pump (FP) G6 , Fuel Level Sensor G and Fuel Level Sensor 3 G237 , assembly overview .
- Before installing fuel delivery unit, pull retaining clasps on support upward - arrows - until it engages.
- Carefully press fuel delivery unit into support until it engages audibly.
- Insert fuel delivery line - 2 - and Fuel Level Sensor 3 G237 - 1 - until it engages audibly.
- Feed supply and return lines of left fuel delivery unit through toward right chamber of fuel tank.
- Through right fuel tank opening, press fuel lines - 1 - and - 2 - on until they engage audibly.
3 - Right fuel delivery unit with Fuel Pump (FP) G23
- Connect electrical connectors - 1 to 3 - on underside of right locking flange.
- Install new locking flange seal dry.
- Insert locking flange in fuel tank, note installation position:
- The tab - 2 - on locking flange must lie between tabs - 1 - and - 3 - on fuel tank.
- Tighten locking ring.
- Install fuel supply line - 2 - and fuel return line - 1 - according to marking until they engage audibly.
- Connect electrical harness connectors - 1 - and - 2 - to right locking flange.
- Fasten cover for right locking flange - arrows -.
- Connect electrical connectors - 1 to 3 - on underside of left locking flange.
- Install new locking flange seal dry.
- Insert locking flange in fuel tank, note installation position:
- Tab - 2 - on locking flange must lie between tabs - 1 - and - 3 - on fuel tank.
- Tighten locking ring.
- Connect electrical harness connectors - 1 - and - 2 - to left locking flange.
- Fasten cover for left locking flange - arrows -.
- Connect battery. Observe safety precautions after connecting battery → 27 - BATTERY, STARTER, GENERATOR, CRUISE CONTROL .
After installing, fuel vehicle with at least 5 liters of fuel