Electromechanical parking brake, removing and installing

Removing 

• Remove battery.

Fig 1: Pulling Locking Slide And Removing Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Pull locking slide in direction of - arrow  - and remove connector - 1  -.
• EPB control module - 2  -

Fig 2: EPB Control Module & Nuts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove nuts - 1  -.
• Remove EPB control module - 2  -

Installing 

Installation is in reverse order of removal, with special attention to the following:

• Install nuts - 1  - , tightening torque 10 Nm
• If control module is replaced, select "Replace" function for respective control module in "Guided Fault Finding".

Vehicle Diagnosis, Testing and Information System VAS 5051.