Inner Tail Lamps, Removing and Installing
Removing
- Switch off ignition and remove ignition key.
- Turn light switch into "0" position.
- Remove luggage compartment lid trim → 70 - INTERIOR TRIM .
- Disconnect connector - arrow -.
- Free up electrical wiring.
- Remove the nuts - 1 - and the tail lamp by removing the sealing strip adhesive on the outer edge.
- If necessary, pull the wire with the grommet out of the luggage compartment lid.
Installing
Install in reverse order of removal, observing the following:
NOTE:
- Replace the double bolts if the sealing washer is damaged.
- Check for proper sealing of grommet between luggage compartment lid and wire.
- Attach a new adhesive strip to the sealing strip and remove the protective film.
- Install luggage compartment lid trim → 70 - INTERIOR TRIM .
Tightening torque
| Component | Nm |
|---|---|
| Rear light to trunk lid | 3 |