Self-Leveling Suspension Control Position, Programming

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2011 Audi A6, 2010 Audi A6, 2009 Audi A6, 2008 Audi A6, and 2007 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Vehicle Diagnosis, Testing and Information System VAS5051A

-- Connect VAS5051A and then perform vehicle-specific entry into Guided Fault Finding and select Go To button "function/component selection". Refer to VAS5051 CONNECTING AND SELECTION FUNCTIONS .

Then

-- "Chassis (Repair group 01; 40 - 49)"

-- "34 - Level control (Repair group 01: 43, 44)".

-- "01 - On Board Diagnostic (OBD) capable systems"

-- "J197 - Level control system control module functions".

-- "J197 - Adapting control position".

NOTE:

If the control position was programmed on vehicles with lane assist, the directional stabilization assistance control module -J759- with integrated camera must be calibrated. Refer to LANE ASSIST CALIBRATION PROCEDURE .