Fuse holder in right instrument panel, removing and installing

Fig 1: Releasing Retaining Springs And Pressing Fuse Holders Toward Rear Out Of Base Mount

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing

With ignition switched off, disconnect battery Ground (GND) wire → Battery, disconnecting and connecting .
Remove glove compartment → 68 - Interior Equipment Removal And Installation .
Release retaining springs - arrows - and press fuse holders - 1 - and - 2 - toward rear out of base mount.

Fig 2: Releasing Clips And Removing Cover From Fuse Holder

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fig 3: Pulling Off Retaining Strip For Harness Connectors And Removing Harness Connectors From Connector Socket

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pull off retaining strip - 1 - for harness connectors - arrow - and remove harness connectors from connector socket.

NOTE:

For the exact assignment of right instrument panel fuse holder refer to the current wiring diagram → Electrical Wiring Diagrams, Troubleshooting and Component Locations.

Installing

Installation is performed in reverse order of removal, noting the following: