Backrest adjustment motor, removing and installing: Notes
Special tools, testers and auxiliary items required
- Engine and transmission holder VAS 6095
- Fixture for seat repair VAS 6136
1 - Four-way lumber support motors (Qty. 2)
2 - Seat height adjustment motor
3 - Seat angle adjustment motor
4 - Longitudinal seat adjustment motor
5 - Backrest adjustment motor
- Removal:
- Remove seat → Front power seats with memory, removing and installing .
- Mount the fixture for seat repair VAS 6136 on the engine and transmission holder VAS 6095.
- Attach the front seat to the fixture for seat repair VAS 6136.
- Remove side trim on sill side → Side panels on door sill side, removing and installing .
- Remove side trim on tunnel side → Side panels on door sill side, removing and installing .
- Remove backrest cover panel → Backrest cover, removing and installing .
NOTE:
- A passenger seat backrest is shown in the illustration.
- Remove bolt from motor for backrest adjustment Removing mount for motor for backrest adjustment .
- Pry out spring washer - 5 - on side of backrest motor with a screwdriver (magnified area of Fig 4- B -.)
- Tap shaft - 4 - through the side of the backrest frame using a hammer and drift punch.
- Pull out shaft - 4 - just far enough out of backrest frame - 1 - until motor for backrest adjustment comes out.
- Installing:
- Adapt the splines of new motor for backrest adjustment Preparing backrest adjustment motor .
- Slide shaft - 4 - through motor for backrest adjustment and through backrest frame - 1 -.
- Set seat aside.
- Place a wood block - 2 - beneath shaft - 4 - (Fig 4 - A -) on opposite side of motor for backrest adjustment.
- Tap spring washer - 5 - onto shaft - 4 - using a socket wrench 11 mm insert - 3 - (Fig 4 - C -).
- Install screw on backrest adjustment motor and connect connector.
Further installation is performed in the reverse order of removal.
For seats with seat memory:
- After installing seat, perform a basic setting for backrest or seat.
1 - Backrest frame
2 - Wood block
3 - Socket 11 mm
4 - Shaft
5 - Spring washer