Rear cross panel trim, removing and installing

Special tools, testers and auxiliary items required 

Fig 1: Torque Wrench V.A.G 1410

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Torque wrench V.A.G 1410

Fig 2: Rear Cross Panel Trim Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Screws (4x)

• Tightening torque 5 Nm

2 - Rear cross panel trim

• Removal:

• Open luggage compartment floor lid.
• Remove screws - 1  - (Qty. 4).
• Carefully remove rear cross panel trim - 2  - from locking pins - arrows  -.

• Installing: 

Installation is reverse of removal. Observe the following when doing so:

• Rear lid rubber must lie over rear cross panel trim.
• Tighten screws to 5 Nm.