Version 2

1 - Cap nut

• Tightening torque → Electrical Wiring Diagrams, Troubleshooting and Component Locations

2 - Screws, (2x)

• Tightening torque 3.5 Nm
• Self-locking
• Replace after each disassembly
• Threaded holes for screws must always be cleaned (for example, with thread cutter)

3 - Screw

• Tightening torque 3.5 Nm
• Self-locking
• Replace after each disassembly
• Threaded holes for screws must always be cleaned (for example, with thread cutter)

4 - Bolts (3x)

• Tightening torque 3.5 Nm
• self-locking
• Replace after each disassembly
• Threaded holes for screws must always be cleaned (for example, with thread cutter)

5 - Screw

• Tightening torque 3.5 Nm
• Self-locking
• Replace after each disassembly
• Threaded holes for screws must always be cleaned (for example, with thread cutter)

6 - Screw

• Tightening torque 3.5 Nm
• Self-locking
• Replace after each disassembly
• Threaded holes for screws must always be cleaned (for example, with thread cutter)

7 - Screw

• Tightening torque 3.5 Nm
• Self-locking
• Qty. 4
• Replace after each disassembly

• Threaded holes for screws must always be cleaned (for example, with thread cutter)

8 - Side curtain airbag

9 - Side curtain airbag connector

• Removal:

• Disconnect the battery ground (GND) strap →
  • 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
  • 27 - BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT - GENERAL INFORMATION
  .

• Remove sun visor → Sun visor, removing and installing .
• Remove upper trim on A-pillar → Upper A-pillar trim, removing and installing .
• Remove D-pillar trim → D-pillar trim, removing and installing .
• Remove trim above rear door → Trim above rear door, removing and installing .

• Disconnect connector - 9  - on side curtain airbag Side curtain airbag connector, disconnecting 
• Remove bolt - 6  -.
• Remove bolts - 2  - (Qty. 2) in area of gas generator.
• Remove cap nut - 1  - in area of gas generator.

• Remove bolts - 4  -, - 5  - and - 7  -
• Remove bolt - 3  -.
• Unclip bracket - 6  - and remaining brackets up to bracket - 3  - from roof frame. Firmly hold side curtain airbag.
• Unclip bracket - 3  - from roof frame and remove side curtain airbag from vehicle.