Oil seal for left Camshaft Position (CMP) sensor, removing and installing: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2004 Audi A6, 2003 Audi S6, 2003 Audi A6, 2002 Audi S6, and 2002 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect connectors from ignition coils -arrows- and move harness aside.

Fig 1: Disconnecting Connectors From Ignition Coils
Courtesy of AUDI OF AMERICA, INC.
Disconnect connector from Camshaft Position (CMP) sensor.
Remove CMP sensor housing (10 Nm/7ft lb).
Remove CMP rotor (23 Nm/17 ft lb) and carefully lever off rotor with screwdriver.
Screw in bolt from oil seal extractor 2085/1.

Fig 2: Identifying Bolt From Oil Seal Extractor 2085/1
Courtesy of AUDI OF AMERICA, INC.
Remove seal with seal extractor 2085 and bolt 2085/1

Fig 3: Removing Oil Seal For Left Camshaft Position (CMP) Sensor Seal With Seal Extractor 2085 And Bolt 2085/1
Courtesy of AUDI OF AMERICA, INC.