Fog lamp housing - Audi A4 with "S-line" equipment Audi S4, removing and installing
Removing
- Turn light switch to position "0".
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Remove air intake grille from fog lamp housing in direction of - arrows -.
- Remove screws - arrows -.
- Disconnect electrical connection.
- Remove housing from opening.
Installing
Install in reverse order of removal, noting the following:
- Check and adjust fog lamps if necessary → 00 - TECHNICAL DATA .
Tightening torques
| Component - fastener | Nm |
| Fog lamp housing to bumper cover - screw | 6 |