Front power seats with memory, removing and installing
Special tools, testers and auxiliary items required
- Torque wrench V.A.G 1332
NOTE:
- Before disconnecting battery: Obtain radio code.
1 - Front seat
- Removal:
- Remove front seat rail covers → Front seat rail covers, removing and installing .
- Remove rear seat rail covers → Rear seat rail covers, removing and installing .
- Push front seat - 1 - fully upward and to the rear.
- Remove front bolts - 2 - (2x).
- Move seat forward.
- Remove rear bolts - 2 - (2x).
CAUTION:
Before removing seat: Disconnect battery ground (GND) strap →
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- 27 - BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT - GENERAL INFORMATION
- Tip front seat - 1 - back.
- Disconnect harness connectors → Disconnecting connections .
- Connect airbag adapter → Airbag Adapter VAS 6036, connecting .
- Installing:
Installation is reverse of removal.
2 - Screws (4x)
- Tightening torque 50 Nm