Fog Lamp, Removing And Installing

Removal

-- Turn off the ignition and remove the key.

-- Turn the headlamp switch to "0".

Vehicles without S Line Equipment:

-- Remove air intake grille -1- in lower part of bumper cover in direction of -arrows-.

Fig 1: Identifying Removal Of Air Intake Grille -1- From Lower Part Of Bumper Cover -Arrows-

Courtesy of AUDI OF AMERICA, LLC

Vehicles with S Line Equipment:

-- Remove the air inlet grille -1- in the lower part of the bumper cover in the sequenced shown in direction of -arrows A and B-.

Fig 2: Identifying Removal Of Air Intake Grille -1- From Bumper Cover In Sequence -Arrow A Then B-

Courtesy of AUDI OF AMERICA, LLC

All Vehicles:

-- Remove screws -arrows- and remove fog lamp housing from bumper cover.

-- Disconnect the connector.

Fig 3: Identifying Fog Lamp Housing And Screws

Courtesy of AUDI OF AMERICA, LLC

Installation

Install in reverse order of removal. Note the following:

-- Adjusting fog lamps, refer to FOG LAMP, ADJUSTING .

Tightening Specifications

Component	Nm
Fog lamp housing to bumper cover	2