Balance Shaft, Removing And Installing: Installing
WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
- Tightening specifications. Refer to OVERVIEW - BALANCE SHAFT .
- Secure crankshaft -1- in "TDC" position using Crankshaft Locking PinT40069.
NOTE:
The balance weights can only be positioned one way on balance shaft.
-- Install the power take-off drive chain. Refer to POWER TAKE-OFF DRIVE CHAIN, REMOVING AND INSTALLING .
-- Install the timing chain cover lower section. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .
-- Install the belt pulley side sealing flange. Refer to SEALING FLANGE WITH CRANKSHAFT SEAL, BELT PULLEY SIDE, REMOVING AND INSTALLING .