Front Flange Shaft And Driveshaft Seal, Transfer Case Installed, Removing And Installing: Removing

Fig 1: Identifying Front/Rear Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- On vehicles with air suspension, activate vehicle lifting mode. Refer to Self-Leveling Suspension .

-- Raise the vehicle.

-- Remove the screws and remove the rear noise insulation -2-.

-- Place the Used Oil Collection and Extraction Unit VAG 1782 under the transfer case.

Fig 2: Identifying Transfer Case Inspection/Drain Plug

Courtesy of AUDI OF AMERICA, LLC

-- Remove the drain plug -2- and drain the transmission fluid.

-- Install the drain plug -2- with Locking FluidAMV 185 101 A1. Tightening specification TRANSFER CASE, CHECKING TRANSMISSION FLUID LEVEL .

-- Position the Engine/Gearbox JackVAG 1383A with the Engine/Gearbox Jack - Gearbox SupportT10337 under the transfer case.

Fig 3: Identifying Engine/Transmission Jack V.A.G 1383A And Installed Gearbox Support T10337

Courtesy of AUDI OF AMERICA, LLC

-- Lift the transfer case slightly using the Engine/Gearbox JackVAG 1383A.

-- Remove the bolts -1 and 2- from the Engine/Gearbox Jack - Gearbox Support.

Fig 4: Identifying Transfer Case Support Bolts -1 And 2-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 and 2- and removed the bracket with the Engine/Gearbox Jack - Gearbox Support from the transfer case.

Fig 5: Identifying Bolts -Arrows- And Transfer Case Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- that connect the front Driveshaft to the transfer case.

Fig 6: Identifying Driveshaft Bolts -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Use the Counterhold - Kit - Multiple UseT10172 and adapters T10172/6.

-- Tie the front Driveshaft to the body.

-- Lower the transfer case slightly.

-- Remove the circlip -1-.

Fig 7: Identifying Locking Ring In Place -1-

Courtesy of AUDI OF AMERICA, LLC

-- Attach the Puller - Multiple UseVW 391 to the flange shaft.

Fig 8: Identifying M8X35 Bolts -A- And M8 Nuts -B-

Courtesy of AUDI OF AMERICA, LLC

A -

M8 x 35 bolts

B -

M8 nuts

-- Remove flange shaft.

-- Make a hole in the center of the shaft seal with a drift.

Fig 9: Identifying Screw -Arrow-

Courtesy of AUDI OF AMERICA, LLC

-- Install the 4 mm diameter -arrow- screws.

-- Remove the shaft seal with Puller - Unit InjectorT10055.

Fig 10: Identifying Removal Of Seal With Puller T10055

Courtesy of AUDI OF AMERICA, LLC