Overview - Coolant Pipes
WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Coolant Pipe on Engine
- Bolt
- 9 Nm
- Left Front Coolant Pipes
- Removing and installing. Refer to LEFT FRONT COOLANT PIPES, REMOVING AND INSTALLING
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Bracket
- Bolt
- 22 Nm
- Bolt
- 2.5 Nm
- Bolt
- 9 Nm
- Front Coolant Pipe
- Removing and installing. Refer to FRONT COOLANT PIPE, REMOVING AND INSTALLING
- Seal
- Replace
- O-Rings
- Replace
- Engine Coolant Temperature Sensor -G62-
- Removing and installing. Refer to Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING
- Bolt
- 5 Nm
- Lower Coolant Pipe on Supercharger
- Together with -20-. Removing and installing. Refer to SUPERCHARGER COOLANT PIPES, REMOVING AND INSTALLING .
- Bolt
- 5 Nm
- Alignment Sleeve
- Seal
- Replace
- Bolt
- 5 Nm
- Seal
- Replace
- Upper Coolant Pipe on Supercharger
- Together with -14-. Removing and installing. Refer to SUPERCHARGER COOLANT PIPES, REMOVING AND INSTALLING .
- Alignment Sleeve
- Bolt
- 5 Nm
- Seal
- Replace
- Seal
- Replace
- O-Ring
- Replace
- Upper Coolant Pipe
- Removing and installing. Refer to UPPER COOLANT PIPE, REMOVING AND INSTALLING
- Bolt
- 9 Nm
- Seal
- Replace
- Bolt
- 9 Nm
- Bolt
- 3 Nm + 90° turn
- Replace
- Bolt
- 3 Nm + 90° turn
- Replace
- Left Coolant Pipes
- Removing and installing. Refer to LEFT COOLANT PIPES, REMOVING AND INSTALLING
- O-Ring
- Replace
- Clamp
Coolant Pipes on Transmission
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Right Coolant Pipe on Transmission
- Removing and installing. Refer to RIGHT COOLANT PIPE ON TRANSMISSION, REMOVING AND INSTALLING
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Left Rear Coolant Pipes on Transmission
- Removing and installing. Refer to LEFT REAR COOLANT PIPES ON TRANSMISSION, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
-- Tighten the bolt -4- to 9 Nm.