LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2007 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (3.0L - Crankshaft & Cylinder Block - Engine Code(S): CJTB, CJTC, CNAA, CJWB, CJWC, CJWE, CTWA, CTWB) >> 13 Crankshaft, Cylinder Block >> Cylinder Block - Belt Pulley Side >> Vibration Damper, Removing And Installing >> Installing

Vibration Damper, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace any bolts that were tightened with an additional turn.

Installation is only possible in one position because of the offset holes.

-- Be careful of the alignment sleeve when installing the vibration damper.

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals