Dust Cap For Flange/Driveshaft, Replacing
-- Press dust cap off of the flange/driveshaft.
A -
Separating device 22 to 115 mm, e.g. Kukko 17/2
-- Press dust cap -A- onto flange/driveshaft.
Installation position of dust cap: Depression on dust cap faces up toward sleeve40 - 20.
-- Press dust cap off of the flange/driveshaft.
A -
Separating device 22 to 115 mm, e.g. Kukko 17/2
-- Press dust cap -A- onto flange/driveshaft.
Installation position of dust cap: Depression on dust cap faces up toward sleeve40 - 20.