Bonded Rubber Bushing

Special tools and workshop equipment required

Thrust pieceVW 442
Thrust pieceVW 554
Sleeve30 - 14
Alignment fixture3301
Alignment fixture3346
Alignment fixture3347

NOTE:

Removal and installation is described for front bonded rubber bushing.

Procedure for removing and installing rear bonded rubber bushing is identical. You must first remove the respective flange shaft. Refer to LEFT FLANGE SHAFT SEAL .

Always grease spindle3346/2 with Molybdenum grease before inserting.

-- Pull out bonded rubber bushing.

Fig 1: Pulling Out Bonded Rubber Bushing

Courtesy of AUDI OF AMERICA, LLC

-- Pull in bonded rubber bushing -A- to stop.

Fig 2: Pulling In Bonded Rubber Bushing To Stop

Courtesy of AUDI OF AMERICA, LLC