Bonded Rubber Bushing At Flange/Driveshaft, Pulling Out And In

Special tools and workshop equipment required 

• Thrust pieceVW 442
• Sleeve30 - 14
• Alignment fixture3301
• Alignment fixture3346
• Alignment fixture3347
• Thrust padVW 512
• Thrust pieceVW 554
• Alignment fixture3253
• Alignment fixtureT10030

-- Pull out bonded rubber bushing.

Fig 1: Pulling Out Bonded Rubber Bushing

Courtesy of AUDI OF AMERICA, LLC

It is important to grease spindle3346/2 with Molybdenum grease before using.

-- Pull in bonded rubber bushing -A-.

Fig 2: Pulling In Bonded Rubber Bushing

Courtesy of AUDI OF AMERICA, LLC

Pull in bonded rubber bushing -A- only so far until dimension -a- BONDED RUBBER BUSHING AT FLANGE/DRIVESHAFT, PULLING OUT AND IN  is obtained.

-- Refer to BONDED RUBBER BUSHING AT FLANGE/DRIVESHAFT, PULLING OUT AND IN .

Fig 3: Identifying Installation Depth For Bonded Rubber Bushing At Driveshaft Flange

Courtesy of AUDI OF AMERICA, LLC

Dimension -a- = 47.5 mm