Turn Signal Bulb, Replacing

Removing 

• With ignition switched off, disconnect battery Ground (GND) wire → Battery, Disconnecting and Connecting .

Fig 1: Locking Bolt & Retainer Tabs

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Loosen locking bolt - 1  - a few turns.
• Remove appropriate front wheel.
• Remove appropriate front wheel housing liner → 66 - EXTERIOR EQUIPMENT .
• Release retainer tabs - arrows  - and detach low beam housing cover from headlamp housing.

Fig 2: Removing Bulbs From Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove bulbs - arrows  - from housing.
• Disconnect connector at bulb.

Installing 

Install in reverse order of removal, observing the following:

• Push socket into reflector until it engages noticeably.
• Close housing cover and secure with screw.
• Install front wheel housing liner → 66 - EXTERIOR EQUIPMENT .
• Connect battery. Required actions → Battery, Disconnecting and Connecting .