5.2L FSI
Removing
- Remove engine → 10 - ENGINE, REMOVING AND INSTALLING .
- Leave transmission with engine installed on Scissor Lift Table VAS 6131.
- Remove bolt - arrow -.
- Remove bracket for connectors - 1 through 4 - from subframe.
- Remove bolts - arrows - at front left and right transmission mounts.
- Twist spindles of support elements left and right at subframe completely downward.
- Remove both base plates of attachments for subframe from scissor lift table VAS 6131.
- Remove attachments.
- Remove subframe to side.
- Turn the spindles for support elements - 1 - (left and right) at engine support - 4 - all the way down.
- Remove bolts - arrows - at left and right engine mounts.
- Remove engine support.
- Remove electrical wiring bracket on right engine support - arrow -.
- Disconnect connector - arrow - at left engine mount.
- Remove bolts - 1 through 4 - and remove engine support with engine mount.
- Disconnect ground cable - 4 - from starter.
- Disconnect electrical wires - 2 - and - 3 - from starter.
- Remove bolts - 1 - and - 5 - and remove starter.
Installing
Install in reverse order of removal, observing the following:
- Install engine → 10 - ENGINE, REMOVING AND INSTALLING .
Tightening Specifications
| Component | Nm | |
|---|---|---|
| Starter to transmission | M10x40 | 45 |
| M10x135 1) | 65 | |
| Terminal B+ to starter | 16 | |
| Ground cable to starter | 22 | |
| Engine support to cylinder block | 40 | |
| 1) Screw property class 10.9. | ||