Cruise Control Switch E45, removing and installing

Fig 1: Identifying Catches, Slip Ring, And Steering Angle Sensor G85

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing 

• Remove Steering Column Switch Module (SCSM) → Steering Column Switch Module (SCSM), removing and installing .

• Carefully release catches - arrows  -.
• Pull return spring with slip ring - 2  - with Steering Angle Sensor G85 - 1  - off from steering column switch module (SCSM).

Fig 2: Identifying Screws, Steering Column Electronics Systems Control Module, And Cruise Control Switch

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove bolts - arrows  -.
• Remove Steering Column Electronic Systems Control Module J527 - 2  - from steering column switch module.
• Disengage Cruise Control Switch E45 - 1  - from steering column switch module (SCSM).

Installing 

Installation is performed in reverse order of removal, noting the following:

• Make sure that all 3 catches as well as the harness connectors are engaged correctly.
• Install Steering Column Switch Module (SCSM) → Steering Column Switch Module (SCSM), removing and installing .

Tightening torques