Removing and installing rear wiper motor

Removing 

• Remove wiper arm → Wiper arm, removing and installing .
• Remove lower rear lid trim → 70 - INTERIOR TRIM REMOVAL AND INSTALLATION .

Fig 1: Identifying Electrical Connection, Washer Fluid Hose, And Nuts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Disconnect electrical harness connector - 2  -.
• Disconnect washer fluid hose - 1  - from connecting pipe of nozzle.
• Unscrew nuts - arrows  - and remove wiper motor.

Installing 

Installation is performed in reverse order of removal, noting the following:

• Carefully attach rubber seal in rear window bore.

• Washer fluid hose must engage audibly into nozzle connection.

• Switch the ignition on.
• Activate "rear wipe" and let wiper motor run in end position.
• Switch off ignition.
• Install lower rear lid trim → 70 - INTERIOR TRIM REMOVAL AND INSTALLATION .

• Adjust wiper arm → Wiper arm, adjusting .