Wiper arms, removing and installing
Removing
NOTE:
- If the windshield wiper motor is to be run during the work procedure, the hood must be closed, otherwise the voltage supply of the wiper motor will be interrupted.
- Switch the ignition on.
- Operate "wipe once" and let wiper arms run to end position.
- Switch ignition off and remove ignition key.
- Pry off cover caps on wiper arms using a screwdriver.
- Loosen nuts - arrows - several rotations.
- Loosen wiper arms successively by tilting slightly from the wiper arm axle.
- Remove nuts completely and remove wiper arms.
NOTE:
- If the wiper arm cannot be pulled off in this way, use a commercially available puller.
Installing
Installation is performed in reverse order of removal, noting the following:
- Adjust wiper arms → Wiper arms, adjusting .