Vehicle Electrical System Control Module J519, removing and installing

Removing 

• If control module is replaced, select "Guided Functions" of respective control module in.
• Switch ignition off and remove ignition key.
• Remove lower instrument panel cover on drivers side → 68 - Interior Equipment Removal And Installation .

Fig 1: Removing Nuts And Vehicle Electrical System Control Module J519

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove nuts - arrows  - and remove Vehicle Electrical System Control Module J519 - 2  -.

Fig 2: Identifying Fuse Holders, Securing Bracket, And Electrical Harness Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Unclip fuse holders - 4 6  -.
• Release securing bracket at connector - 1  - and remove it.
• Disconnect electrical harness connectors - 2  - and - 3  -.

Installing 

Installation is performed in reverse order of removal, noting the following:

• Install lower instrument panel cover on drivers side → 68 - Interior Equipment Removal And Installation .

Tightening torque