Special Purpose Vehicle Control Module J608, removing and installing

Removing 

• If control module is replaced, select "Guided Functions" of respective control module in.
• Switch ignition off and remove ignition key.
• Remove glove compartment → 68 - Interior Equipment Removal And Installation .

Fig 1: Identifying Bolts, Special Purpose Vehicle Control Module J608 From Bracket, And Electrical Harness Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove bolts - arrows  -.
• Remove Special Purpose Vehicle Control Module J608 - 1  - from bracket.
• Disconnect electrical harness connector - 2  -.

Installing 

Installation is performed in reverse order of removal, noting the following:

• Install glove compartment → 68 - Interior Equipment Removal And Installation .

Tightening torque