2-pin relay and fuse carrier behind instrument panel, drivers side, removing and installing
Removing
- With ignition switched off, disconnect battery Ground (GND) wire → Battery, disconnecting and connecting .
- Remove lower instrument panel cover on drivers side → 68 - Interior Equipment Removal And Installation .
- Remove bolts - arrows -.
- Remove relay and fuse carrier - 1 -.
If necessary, proceed with work steps.
- Unclip fuse holder at relay and fuse carrier.
- Disconnect relays and unclip respective relay carrier.
NOTE:
- For the exact assignment of the 2-pin relay and fuse carrier behind instrument panel on drivers side, refer to the current wiring diagram → Electrical Wiring Diagrams, Troubleshooting and Component Locations.
Installing
Installation is performed in reverse order of removal, noting the following:
- Install lower instrument panel cover on drivers side → 68 - Interior Equipment Removal And Installation .
- Connect battery. Required actions Battery, disconnecting and connecting .
Tightening torque
| Component | Nm |
| Relay and fuse carrier to central tube for instrument panel | 3 |