Left Rear Window Switch E52 / Right Rear Window Switch E54, removing and installing
Fig 1: Disconnecting Electrical Harness Connector For Window Regulator Switch And For Ashtray Illumination
Removing
CAUTION:
- Switch off all electrical components.
- Switch ignition off and remove ignition key.
- Remove rear door trim → 70 - INTERIOR TRIM REMOVAL AND INSTALLATION .
- Remove bolts - arrows -.
- Disconnect electrical harness connector - 1 - for window regulator switch and for ashtray illumination - 2 -.
- Remove armrest at door trim.
- Carefully release catches - arrows - using a small screwdriver.
- Pull rear window switch - 1 - downward out of switch mount.
Installing
Installation is performed in reverse order of removal, noting the following:
- Press switch into switch mount until catches engage.
- Install rear door trim → 70 - INTERIOR TRIM REMOVAL AND INSTALLATION .
Tightening torque
| Component | Nm |
| Armrest to door trim | 2.5 |