Garage Door Opener Control Module J530, removing and installing

Fig 1: Identifying Bolt, Harness Connector, And Garage Door Opener Control Module

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing 

• Remove front bumper cover → 63 - Bumpers Removal And Installation .
• Remove bolt - 3  - and remove retaining bracket - 4  -.
• Remove Garage Door Opener Control Module - 2  - out of bumper cover.
• Disconnect electrical harness connector - 1  -.

Installing 

Installation is performed in reverse order of removal, noting the following:

• Install front bumper cover → 63 - Bumpers Removal And Installation .

Tightening torque