Overview - Steering Column Switch Module

Fig 1: Identifying Steering Column Switch Module (SCSM), Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

1. Coil Connector with Slip Ring
   • Removing and installing, refer to AIRBAG SPIRAL SPRING/RETURN SPRING WITH SLIP RING 
     CAUTION:

     Coil connector with slip ring is not to be turned following removal.

2. Steering Angle Sensor -G85-
   • Removing and installing, refer to Steering Angle Sensor -G85- 
3. Socket Head Bolt
   • 0.65 Nm
4. Cruise Control Switch -E45-
   • Removing and installing, refer to Cruise Control Switch -E45- 
5. Socket Head Bolt
   • 0.65 Nm
6. Turn Signal Switch -E2-
   • Removing and installing, refer to Turn Signal Switch -E2- 
7. Retainer
8. Steering Column Electronic Systems Control Module -J527-
   • Removing and installing, refer to Steering Column Electronics Control Module -J527- 
   • Connector assignment of steering column electronic systems control module, refer to Steering Column Electronics Control Module -J52-, CONNECTOR ASSIGNMENT, FRONT SIDE 
9. Clamping Bolt
   • 3 Nm
10. Windshield Wiper/Washer Switch -E22-
    • Removing and installing, refer to Windshield Wiper Intermittent Mode Switch -E22- 
11. Socket Head Bolt
    • 0.65 Nm

refer to OVERVIEW - STEERING COLUMN SWITCH MODULE .

Fig 2: Identifying Bolts, Handle, Torx Bolts, Upper Trim, And Lower Trim

Courtesy of AUDI OF AMERICA, LLC

1. Lower steering column switch trim
2. Upper steering column switch trim
3. Bolt - 0.6 Nm
4. Bolt - 0.6 Nm
5. Handle for manual steering column adjustment
6. Bolt - 3.5 Nm