Handle mount trim, assembly overview

1 - Handle mount trim

• Removing 
• Pry out cover - 2  - using a small flat screwdriver.
• Remove bolt - 3  -.

• Turn handle.
• Pry out cover - 2  - on other side, using a small flat screwdriver.
• Remove second bolt - 3  -.
• Remove bolts - 4  - from underneath.

• Unclip handle mount trim - 1  - from clips - 5  - (2x).
• Pry out clamp - 6  - (always replace clamp - 6  -).
• Detach Bowden cable - 7  - from handle.

2 - Cover (2x)

3 - Bolts (2x)

• Tightening torque 9 Nm

4 - Bolts (2x)

• Tightening torque 7 Nm

5 - Clips (2x)

6 - Fastener

• Always replace

7 - Bowden cable