Front anchorage point for outer floor panel

• Removing 

Fig 1: Identifying Trim Cap, Bolt, Washers, Clips & Belt

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Detach trim cap - 3  -.
• Remove bolt - 2  -.

• Tightening torque 55 Nm

• Remove washer - 4  -.
• Swing clip - 5  - upward.
• Remove belt - 1  - from clip - 5  -.

• Installing 

• Install washer - 6  - under clip - 5  -.
• Continue installing anchorage point for outer floor panel in reverse order of removal.