Steering wheel (multi-function steering wheel), assembly overview

1 - Torx bolts T30 (2x)

• Tightening torque 7 Nm

2 - Steering wheel

• Removing 

• Remove airbag unit (multi-function steering wheel) → Refer to → Airbag unit (multi-function steering wheel), assembly overview .
• Center steering wheel (wheels in straight-ahead position).
• Remove bolt - 6  -.
• Disconnect connector for coil - 3  -.

• Disconnect multi-function cable connector - 9  -.
• Heated steering wheel: Unplug connector for heated steering wheel - 10  -.
• Remove steering wheel - 2  -.

• Installing 

• Installation is in reverse order of removal.
• Ensure that connector and catch engage fully (i.e. audibly).
• Insert supply cable - 7  - in clip - 8  -.
• Attach steering wheel in center position (wheels in straight-ahead position).

• Replace bolt - 4  - and tighten to 50 Nm.

3 - Connector for coil

4 - Connector for airbag unit

5 - Airbag unit

6 - Multi-point socket head bolt

• Tightening torque 50 Nm

7 - Supply cable

8 - Clip

9 - Connector for multi-function steering wheel

10 - Connector for heated steering wheel

11 - Self-cancelling ring with slip ring