Delivery rate of fuel pump, checking (vehicles with 6-cyl. MPI-engine)
Special tools, testers and auxiliary items required
- Remote control V.A.G 1348/3A with adapter cable V.A.G 1348/3-2
- Measuring container, fuel-resistant
Test conditions
- Battery voltage at least 12.5 V.
- Fuel filter OK
- Fuel tank at least 1 /4 filled.
- Fuel pressure regulator OK, checking →
- 24 MULTIPORT FUEL INJECTION (MFI) for 1.8 LITER 4-CYL. 5V TURBO FUEL INJECTION & IGNITION, ENGINE CODE(S): AMB
- 24 - MULTIPORT FUEL INJECTION (MFI) for 2.0 LITER 4-CYL. 4V TURBO FUEL INJECTION IGNITION, ENGINE CODE(S): BPG, BWT
- 24 MULTIPORT FUEL INJECTION (MFI) for 3.0 LITER 6-CYL. 5V FUEL INJECTION & IGNITION, ENGINE CODE(S): AVK, BGN
- 24 - FUEL INJECTION SYSTEM for 3.2 V6 4V FUEL INJECTION IGNITION, ENGINE CODE(S): BKH
- 24 - MULTIPORT FUEL INJECTION (MFI) for 4.2 LITER V8 4V FUEL INJECTION AND IGNITION, ENGINE CODE(S): BNS
- 24 MULTIPORT FUEL INJECTION (MFI) for 4.2 LITER V8 5V FUEL INJECTION AND IGNITION, ENGINE CODE(S): BHF
- Ignition switched off.
Test sequence
- Open cover of fuse box at left side of instrument cluster.
- Pull out fuse on fuse panel S228 (left row, 5th large fuse from top).
Fig 2: Connecting Remote Control V.A.G 1348/3A With Adapter Cable V.A.G 1348/3-2 To Right Socket Terminal Of S228
- Connect remote control V.A.G 1348/3A with adapter cable V.A.G 1348/3-2 to right socket terminal of S228.
- Connect alligator clip to vehicle battery (+).
- Remove fuel filler cap from fuel filler tube.
CAUTION:
The fuel system is under pressure! Before opening system, place rags around the connection area. Then release pressure by carefully loosening the connection.
- Disconnect fuel return hose from line connection on fuel rail pipe.
- Connect assisting hose onto fuel rail - arrow - and hold it in a measuring container.
- Press switch on remote control for 15 seconds.
- Compare quantity of fuel delivered with minimum delivery rate in diagram (cm 3 /15s).
NOTE:
- Voltage at fuel pump with engine stopped and pump running is approx. 2 volts less than battery voltage.
Installation is in reverse order of removal. Note the following:
NOTE:
- Secure all hose connections using hose clamps appropriate for the model type .
- Install fuel return hose.