Fuel delivery unit, removing and installing: Removing
Observe safety precautions → Safety precautions when working on fuel supply system .
Observe rules for cleanliness → Rules for cleanliness .
CAUTION:
- To remove the fuel delivery unit, the fuel tank may only be filled to a maximum of 1 /4 . Drain fuel tank if necessary. Procedure → Fuel tank, draining .
- Observe procedures for disconnecting battery →
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT, CABRIOLET
- Push cover over battery toward right - arrow 1 - and remove it upward - arrow 2 -.
- With ignition switched off, disconnect Battery Ground (GND) strap - arrow -.
- Open fuel filler flap briefly and then close again.
- Remove rear seat bench →
- 72 - SEAT - FRAMES
- 72 - SEAT - FRAMES for BODY INTERIOR - CABRIOLET
- Unbolt cover for right locking flange - arrows -.
- Disconnect electrical harness connector - 1 - at right locking flange.
- Disengage electrical harness connector - 2 - and lay it aside.
CAUTION:
The fuel system is under pressure! Before opening system, place rags around the connection area. Then release pressure by carefully loosening the connection.
- Disconnect fuel line - 1 - from locking flange by pressing release button.
- Disconnect ventilation line - 2 - by pressing release buttons.
CAUTION:
Locking flange may only be opened when fuel tank is maximum 1
/4
full. Otherwise, a large amount of fuel will spill out.
- Remove locking ring using wrench T10202.
- Pull locking flange and sealing ring from opening of fuel tank.
- Disconnect electrical connection on the inner side of the locking flange - arrow -.
NOTE:
- To improve clarity, a cross-sectional view of the fuel tank is shown in the following illustration.
- Guide fuel pump wrench 3307 through fuel tank opening and place it on fuel delivery unit.
- Release fuel delivery unit with fuel pump wrench 3307 , thereby turning approx. 15 ° toward left until stop (bayonet connection).
- Notch - 1 - aligns with marking - 2 -.
- Remove fuel delivery unit.
NOTE:
- Be aware that fuel is still in the fuel delivery unit.