Part I oil pan, balance shaft module, component overview

Part II Balance shaft module, oil pump → Part II balance shaft assembly with oil pump, component overview 

1 - 15 Nm

2 - Oil dipstick

• Oil level must not be above max. mark!

3 - Inlet spout

4 - Guide tube

5 - Intermediate plate

6 - Balance shaft module with oil pump

• With pressure relief valve 12 bar
• Removing and installing → Balance shaft module with oil pump, removing and installing 

7 - 15 Nm plus an additional ¹ /₄ turn (90 °)

• Replace
• Note different length of bolts Bolt allocation for balance shaft housing 

8 - 15 Nm

9 - Oil pan

• Clean sealing surface before installing
• Removing and installing → Oil pan, removing and installing 

10 - 15 Nm

11 - Seal

12 - Oil drain plug, 30 Nm

• With permanent sealing ring
• Replace

13 - Chain sprocket

14 - 10 Nm

15 - Protective cap

16 - Oil Level Thermal Sensor G266

17 - Seal

• Replace
• Oil before assembling

18 - 20 Nm plus an additional 90 °

• Replace

19 - Chain guard

20 - Chain

21 - Sealing flange

• Must be located on dowel sleeves
• Seal for crankshaft - belt pulley side, replacing → Crankshaft seal - ribbed belt side, replacing