Camshaft Adjustment Valve 1 N205 , removing and installing

Fig 1: Identifying Special Tools - Camshaft Adjustment Valve 1 N205 , Removing And Installing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Special tools, testers and auxiliary items required

Removing

NOTE:

Fig 2: Removing Engine Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fig 3: Separating Electrical Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

NOTE:

Fig 4: Removing Bolts And Camshaft Adjustment Valve 1 N205 From Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts - arrows - and remove Camshaft Adjustment Valve 1 N205 from housing.

Installing

NOTE:

Camshaft Adjustment Valve 1 N205 as well as housing must be free of dirt and contamination.
Remove new Camshaft Adjustment Valve 1 N205 from packaging only prior to installation.

CAUTION:

Coat sealing ring with engine oil.
Carefully insert Camshaft Adjustment Valve 1 N205 into housing and press it in perpendicular to valve axle by hand as far as stop.
Install bolts and tighten to 4 Nm with Torque Wrench V.A.G 1783 , Ratchet Adapter 1/4 VAS 6234 , TORX-Bit T20 and Bithalter from TORX bit set V.A.G 1766.

The rest of assembly is basically a reverse of disassembling sequence.

Torque specifications

Component	Nm
Camshaft Adjustment Valve 1 N205	4