Windshield Wiper/Washer Switch E22 , removing and installing

Removing

CAUTION:

Ensure steering is in straight ahead and centered prior to removing spiral spring.
Position of spiral spring must not be changed once removed.

Fig 1: Releasing Clip Fasteners To Remove Spiral Spring From Steering Column Switch Module

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Carefully release clip fasteners - arrows - and remove spiral spring - 1 - from steering column switch module.

Fig 2: Removing Steering Angle Sensor G85 From Steering Column Electronic Systems Control Module J527

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove Steering Angle Sensor G85 - 1 - from Steering Column Electronic Systems Control Module J527 in direction of - arrow -.

Fig 3: Identifying Screws And Windshield Wiper/Washer Switch

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove screws - 1 - and - 2 -.
Remove Windshield Wiper/Washer Switch E22 - 3 - from steering column switch module - arrow -.

Installing

Further Install in reverse order of removal, noting the following:

Ensure all fasteners and electrical connectors are properly connected and locked into place.
Install steering column switch module Installing .

Tightening torque

Component	Nm
Windshield Wiper/Washer Switch E22 to Steering Column Electronics Systems Control Module J527	0.6