Cruise Control Switch E45 , removing and installing

Removing 

• Remove steering column switch module → Steering column switch module, removing and installing .

Fig 1: Releasing Clip Fasteners To Remove Spiral Spring From Steering Column Switch Module

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Carefully release clip fasteners - arrows  - and remove spiral spring - 1  - from steering column switch module.

Fig 2: Removing Steering Angle Sensor G85 From Steering Column Electronic Systems Control Module J527

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove Steering Angle Sensor G85 - 1  - from Steering Column Electronic Systems Control Module J527 in direction of - arrow  -.

Fig 3: Identifying Screws, Steering Column Electronics Systems Control Module, And Cruise Control Switch

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove screws - arrows  -.
• Remove Steering Column Electronics Systems Control Module J527 - 2  - from steering column switch module.
• Remove Cruise Control Switch E45 - 1  - from steering column switch module.

Installing 

Further Install in reverse order of removal, noting the following:

• Ensure all fasteners and electrical connectors are properly connected and locked into place.
• Install steering column switch module Installing .

Tightening torques